PRE
INSTALLATIO
N
PROCEDURES
Ducted Mode
Recirculating Mode
(Fig. 1) Knob Settings
Ducted Mode
: Turn the knob
to this
setting for Ducted Installation.
Recirculating Mode
: Turn the knob
to this setting for a Recirulating
Installation.
• Please read the instructions carefully. Unpack the Range Hood and check that all
functions are working before installing.
• Ensure that the voltage (V) and the frequency (Hz) indicated on the sticker match the
voltage and frequency at the installation site.
• Check that the area behind the installation surface to be drilled is clear of any electrical
cables or pipes, etc.
• The stainless steel surfaces of the Range Hood are very easily damaged during
installation if scratched or bumped by tools. Please take care to protect the surfaces
during installation.
• Protect the cooktop surface below with cardboard, or the like, to prevent damage
occurring during installation.
• The manufacturer shall not be held liable for failure to observe all safety regulations.
You will need to set the Range Hood mode to either Ducted or Recirculating.
1. Remove Aluminum Filters
2. Locate Knob Settings
located under the
Motor
(Fig. 1)
3. Unlock the Settings Knob by unscrewing and setting to Ducted or Recirculating mode.
4. Lock the Knob into place by replacing the screw from
Step 3
.
IMPORTANT READ BEFORE INSTALLATION
7
