12
2 . Installation instructions according collection: Cosiflow square & straight
The Cosiflow is supplied complete with pressure regulator (30 mbar) and gas hose. You only need to purchase a
gas bottle. These can be purchased at your local gas supplier.
1. Installing the Cosiflow
Carefully remove your Cosiflow from its packaging and select the location for your Cosiflow. The location must
meet the following conditions:
-
Make sure that the Cosiflow is placed on a paved (preferably stone) surface. The surface should be
completely flat and clean.
-
The Cosiflow should be placed at least two meters away from flammable materials and liquids.
-
After placing the frame on a stable surface, you can now place the table top onto the frame. Then you
can place the burner into the recess in the table top.
Before the Cosiflow is ready to use you have to place an AAA battery for the piezo ignition. Please see ‘2.5
Replacing the battery for the piezo ignition.’
When the Cosiflow is installed properly, you can place the lava rocks and ceramic logs on the top. Start by
unpacking the small lava rocks and place these on the ground. Every product from Cosiflow is supplied with small
and large lava rocks. Take the small lava rocks without grit and place these gently on the model. Repeat the
process with the big lava rocks and make sure the fire ring is covered with lava rocks. Keep the space around the
ignition unit free of lava rocks.
After placing the lava rocks, unpack the ceramic logs. The Cosiflow is always supplied with four pieces. You can
place the ceramic logs as a camp fire over the burner ring. It is recommended to place the ceramic logs as follows:
Make sure the fire ring is only minimally covered by the logs. If the logs block the fire ring, dangerous situations
may occur. The blockade of the fire ring will affect the air flow of the ring and the flames will be different. This
results in dangerous situations!
If you want to order more lava stones or ceramic logs, this is possible at your purchase address.
Pay Attention:
When you are going to use the Cosiflow for the first time, make sure that the device is turned at
the highest setting for 15 minutes. In this way, the lava stones are heated through and this ensures that any
bumps or air bubbles will disappear from the lava rocks. During the first time the Cosiflow is turned on or when
the lava rocks have been wet (after some rain), keep at least
two meters away
from the burner and also ensure
that
no flammable materials are placed
around or on the table within this
radius of two meters
. Because the
air bubbles are burned from the lava stones, the stones can jump up during the first time / when lava rocks have
been wet and possibly come out of the burner.