Coseng C211 C, Руководство по эксплуатации

Страница: 8 / 30

- 7 -
6.OPERATING INSTRUCTION
6-1 To Preliminary Operating Tests
1) Connect the tire changer to its air and electrical supply sources, and allow adequate
time for the compressed air system to reach the recommended 110-PSI.
2) Depress the Reverse Pedal (3,Fig2) down, the turntable should turn in a clockwise
direction. Pull the pedal up and the turntable should turn anticlockwise.
3) Press the bead breaker pedal (1,Fig2)to activate the paddle. When the pedal is
released. The pedal should return to its original position.
4) Press the jaw clamp pedal (2,Fig.2) once to open the four jaws. Press the pedal again
to close the jaws.
5) Press the trigger on the air gauge to release air from the nozzle.
Notice: Inflation gun is tire changer’s standard accessory. It is not included when IT,
IP or IE installed.
6-2 To Break Tire Bead
1) CAUTION: Before carrying out this procedure, deflate the tire fully, and remove all the
wheel weights.
2) Close the turntable clumping jaws completely.
3) Open the bead breaker arm by hand by pushing it towards the outside. Place the wheel
up against the Rubber Buffer. Bring the Paddle against the bead about 10mm from the
edge of the rim. (see Fig.5 )
4) Depress the bead breaker pedal fully to activate the paddle. Release pressure on the
bead breaker pedal. When the blade has reached the end of its travel and / or when the
tire bead is broken.
5) Rotate the tire slightly, and repeat the procedure around the entire circumference of the
wheel rim until the bead is completely detached from the rim. (Fig.5)
6) Repeat the above steps for the other side of the wheel / tire.
Fig.5
6-3 To Remove The Tire From The Wheel
1) CAUTION: Before carrying out this procedure, deflate the tire fully, and remove all the
wheel weights.
2) Spread tire grease (or a similar lubricant) liberally on the complete circumference of the
broken tire bead.
NOTE: Failure to lubricate the tire bead may cause serious damage to the bead.
3) Place the wheel / tire evenly on the turntable.(4,Fig.2)
4) To lock the wheel on the turntable, proceed as follows according to the wheel size:
Outside Clamping:
Position the four jaws (5,Fig.2) according to the reference mark located on the turntable by
depressing the jaw clamp pedal (2,Fig.2) halfway down.