CorroVenta A15ES, Руководство пользователя

Страница: 16 / 67

A15ES
© Corroventa Avfuktning AB 2022.05 16 (67)
5. Check that the power cable to be used is intact and without visual damage. Connect the
machine to 16A 400V 3-phase supply, preferably protected by RCD.
6. Start the machine by turning the mains power switch clockwise to position 1. When the
display starts up, push Resume to continue operation with the settings last used. Push of
Start will get the machine running at maximum capacity (Max mode) and with continuous
operation (control mode Manual
7. Observe that the start sequence takes a few minutes. The last thing to start, at first at low
speed and then slowly increasing to the intended level for the capacity mode selected is the
regeneration fan.
8. Check that the air flows are as expected and that there are no leaks with the ducting.
9. If the machine is equipped with differential pressure sensor for balancing, continue by
adjusting the fan speeds to the ducting by following the process described in chapter
Adjusting air flow balance.
10. If the machine is equipped with filter monitoring, verify and if required adjust the settings
following the instructions provided in chapter Filter monitoring
Start and stop the machine
The machine is equipped with a mains power switch positioned in the lower left corner of the
electronics cabinet hatch.
To start the machine:
1.
Turn the mains power switch clockwise to position 1.
2. Await the control panel start up.
3. Once the default view is presented on the control panel, there are two
alternatives presented, Start to the left and Resume to the right.
Select Resume to continue operation with the settings last used with the machine.
Select Start for default operation ignoring previous settings and applying
maximum capacity (Max mode) and continuous dehumidification (control mode
Manual)
Note: The machine will automatically resume operation after power outages. If
this has happened or if last time the machine was used, its operation was not
stopped through the control panel before the mains power switch was turned off,
the default view will present a count down from 30 seconds after which the
machine will automatically resume. If this is not desirable, the automatic restart
can be stopped by push of Stop, the lower centre button of the control panel.
4. The machine will now start its components in sequence. The start procedure is
automatic and takes about five minutes.
To stop the machine:
1.
Push Stop on the control panel.