corob D600 extra, Руководство пользователя

Страница: 43 / 50

ORDINARY MAINTENANCE
- 43 -
COROB™ D600 - D700 - D800TX
7.6 Cleaning and moistening the humidifier cap sponge
In case of sponge replacement, use only those supplied with the machine.
8 mm To remove the Autocap screw(s)
DANGER
IF THE MACHINE IS EQUIPPED WITH PUNCHING DEVICE, YOU MUST WEAR CUT-PROOF GLOVES.
1. Open the Autocap using the command in the management software.
2. Disconnect power supply (chapter 5.6).
3. If present, open the inspection door in the dispensing area.
4. Loosen screw A (if present) and remove the sponge support B by turning it counter-clockwise.
WITHOUT HUMIDIFIER SYSTEM WITH SOLVENT HUMIDIFIER
SYSTEM
WITH WATER HUMIDIFIER
SYSTEM
a. Check the condition of the
sponge and moisten as needed.
The level of the humidifying
liquid must not exceed the
height of the sponge. If it is very
dirty, remove the sponge from
the cap and wash it thoroughly.
b. Check the condition of the
sponge. If it is very dirty, remove
the sponge from the cap and
wash it thoroughly. Top up with
a small quantity of solvent the
tank inside the sponge support;
when repositioning the sponge
on the filter, be careful to dip
the tail into the solvent.
c. Check the condition of the
sponge. If it is very dirty,
remove the sponge from the
cap and wash it thoroughly.
B
A