-Save these instructions-
CSEVS22T 2 03/10/20
This is the safety alert symbol . It is used to alert you
to potential personal injury hazards . Obey all safety
messages that follow this symbol to avoid possible
injury or death .
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
THE NATURE OF HAZARDOUS SITUATIONS
METHODS TO AVOID HAZARDOUS SITUATIONS
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsi-
bility of the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product
labels are lost or not legible, contact Cornwell for replacements. If the operator is not fluent in English, the product and safety
instructions shall be read to and discussed with the operator in the operator's native language by the purchaser/owner or his
designee, making sure that the operator comprehends its contents.
The use of portable automotive supporting devices are subject to certain hazards that cannot be prevented by mechanical
means, but only by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel
involved in the use and operation of the equipment who are careful, competent, trained, and qualified in the safe operation of
the equipment and its proper use. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improp-
erly securing loads, overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a purpose
for which it was not designed.
• Read, study, understand and follow all instructions before operating this device
• User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards
• Inspect the jack stands before each use. Do not use if damaged, altered, modified, in poor condition or unstable due to loose
or missing hardware or parts. Make corrections before using the stands
• Use as a matched pair only
• Use only on a hard level surface capable of supporting the load
• Stands are to be used in matched pairs to support one end of the vehicle only. Do not simultaneously support both ends or
one side of the vehicle.
• Center load on saddle. Do not use saddle lugs to support the load
• Do not use jack stands beyond its rated capacity. Do not shock load
• Maximum load capacity per matched pair shall not exceed the rated capacity of the individual stand
• Apply the emergency brake and put the gear shift lever in park or in gear if a manual shift transmission, and chock the tires
that will not be lifted off the ground
• Check the stands for solid contact with the ground and vehicle
• Make sure the stand's locking pins are fully engaging the stand on both sides and the support column saddle is making
contact with a vehicle support surface that can support the load
• Ensure both stands are set at same height and locking pins are fully engaged
•
Do not crawl under vehicle when placing/removing stands
• Consult the vehicle manufacturer for the proper frame support locations
• No alterations shall be made to these stands
• Never use the stand's lower support plate (if so equipped) as a load bearing surface for the locking pin
• Failure to heed these warnings may result in serious or fatal personal injury and/or property damage
WARNING:
Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury .
WARNING
WARNING
WARNING
WARNING:
This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer and
birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CSEVS22T
22 Ton Jack Stands (pair) - Blue
