Corning Restricted and Confidential Proprietary - Controlled content
SCRN-510 Hardware Installation Guide | DOC-SCRN-510-HIG_i4 | 16 October, 2020 | Page 2
FCC Statement
Safety Precautions
Corning strongly recommends reviewing and adhering to the following cautions and notices before installing
and operating the SCRN-510.
Caution:
Any changes or modifications to this device not explicitly approved by manufacturer could void
your authority to operate this equipment.
RF Exposure warning statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum 4
0
cm between the radiator and your body.
This transmitter must not be collocated or operating in conjunction with any other antenna or transmitter
unless authorized to do so by the FCC.
This device can be expected to comply with part 15 of the FCC Rules provided it is assembled in exact accor
-
dance with the instructions provided with this kit. Operation is subject to the following conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received includ
-
ing interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device, pur
-
suant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruc
-
tion manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
WARNING:
This warning symbolizes danger that may cause severe injury or death. Before installing
or servicing equipment ensure that you are aware of all hazards involved with electrical circuitry and
become familiar with applicable safety standards and national and local electrical codes and any
other relevant standards.
WARNING:
Do not locate outdoor antennas near overhead power lines or other power circuits that
might come into contact with the antennas and their wiring. Contacting such circuits during installa
-
tion can cause severe injury or death. Refer to national and local electrical codes and any other rele
-
vant standards for more safety information.
WARNING:
Ensure that you install a suitable lightning arrestor for outside antenna installations.
WARNING:
Do not use or service any equipment with outdoor connections during electrical storms
due to risk of lightning.
WARNING:
All electrical equipment must be properly grounded. Refer to national and local electrical
codes and any other relevant standards for electrical grounding information.
WARNING:
If an external antenna starts to fall during installation, for models that are designed for
external antennas, let it drop as it may contact a power line or other electrical circuitry that might
cause severe injury or death.
