STANDARD RECOMMENDED PROCEDURE 003-809 | ISSUE 4 | DECEMBER 2011 | PAGE 3 OF 4
=
Step 6:
Once the kit is secured in position, install the EDGE-01U or EDGE-04U housing, as
applicable, or any other device that has the ability to be installed into a 19-inch rack
space, by securing the mounting brackets on each side into the mounting holes on front
of the kit. If installing only one housing, place it in the top position.
Step 7:
To prevent the housings from tilting in the rack, insert screws into the sides of the housing
as shown in Figure 2.
5.
Rackless Ladder Rack Mounting Kit 2U or 4U
Step 1:
Loosen the screws as shown in Figure 3 to allow the rails to slide.
Step 2:
Place the mini-frame in the middle of the cross members. Slide the Omega brackets to
the left and right to lock the system in the horizontal (X) axis.
NOTE:
The kit is able to move in X and Z directions.
Step 3:
Adjust the kit location in the Z direction (forwards or backwards) so the housing will align
with the front of the cabinet below, if present. Consider the 4.5-inch frontal projection in
your calculations. Tighten the screws on the underside of the mini-frame.
KPA-2558
~4.5 inch
~4.5 inch
2U
4U
Pretium EDGE™
Pretium EDGE™
Pretium
EDGE™
Figure 2 — Install Housing(s) into Mounting Kit
2
Z axis
X axis
1
KPA-2517
2
Z axis
X axis
1
2U
4U
Figure 3 — Install Rackless Ladder Rack Kit (2U or 4U)
