10
11
CORNING LSE MULTI PURPOSE DIGITAL VORTEXER
Instruction Manual
◗
◗
If you want to change the RPM during vortexing, push the encoder knob to put the
Vortexer into RPM set mode (RPM signal light will be on). Rotate the encoder right (+)
or left (-) to set the desired value. In the meantime RPM signal light will flash. When
you stop rotating the encoder knob, the signal light for RPM will stop flashing after 2
seconds.
5.3. Additional Operations
◗
◗
If you want to view the set value for RPM during vortexing, rotate the encoder knob
for ONE CLICK right (+) or left (-). The RPM signal light will flash for 2 seconds and the
display will show the set RPM. After 2 seconds the RPM and the signal light will stop
flashing.
NOTE:
The Vortexer must be in RPM mode – RPM signal light must be on.
◗
◗
If you want to view the set value for TIME during vortexing, rotate the encoder ONE
CLICK right (+) or left (-). The TIME signal light will flash for 2 seconds, and the display
will show the set TIME. After 2 seconds the display will return to the count TIME, and
the signal light will stop flashing.
NOTE:
The Vortexer must be in the TIME mode – the TIME signal light must be on.
Power
Run
Speed (RPMx10) time (min)
Time
Speed
Start
Stop
PUSH
(Time/Speed)
ENCODER
Power
Run
Speed (RPMx10) time (min)
Time
Speed
Start
Stop
PUSH
(Time/Speed)
ENCODER
Power
Run
Speed (RPMx10) time (min)
Time
Speed
Start
Stop
PUSH
(Time/Speed)
ENCODER
Power
Run
Speed (RPMx10) time (min)
Time
Speed
Start
Stop
PUSH
(Time/Speed)
ENCODER
◗
◗
When the run time has elapsed or when you press the START/STOP button, the display
will show “End” and the RUN light will flash. When the Vortexer completely stops the
set speed and time will return to the last programmed values.
