CORNING LSE 6709, Инструкция по эксплуатации

Страница: 5 / 9

8 9
CORNING LSE MULTI PURPOSE DIGITAL VORTEXER
Instruction Manual
◗ ◗
TIME signal light is on. By rotating the encoder right (+) or left (-) the set time can be
selected from 30 seconds to 99 minutes 50 seconds:
• 99.5 = 99 minutes 50 seconds
• 9.59 = 9 minutes 59 seconds
• 0.30 = 30 seconds
◗ ◗
If you want to set the timer to hold – turn the knob left or right until HLd is displayed.
You can reach the HLd function by setting to under 0.30 or above 99.5.
◗ ◗
Push down on the encoder knob to switch modes between TIME set mode and RPM set
mode.
◗ ◗
RPM signal light is on. By rotating the encoder right (+) or left (-) the desired RPM can
be selected:
• 34 = 340 rpm
• 120 = 1,200 rpm
◗ ◗
Press the START/STOP button to start operation.
Power
Run
Speed (RPMx10) time (min)
Time Speed
Start
Stop
PUSH
(Time/Speed)
ENCODER
Power
Run
Speed (RPMx10) time (min)
Time Speed
Start
Stop
PUSH
(Time/Speed)
ENCODER
Power
Run
Speed (RPMx10) time (min)
Time Speed
Start
Stop
PUSH
(Time/Speed)
ENCODER
Power
Run
Speed (RPMx10) time (min)
Time Speed
Start
Stop
PUSH
(Time/Speed)
ENCODER
◗ ◗
RUN and TIME signal lights are on. The Vortexer runs and counts down the time from
the set value.
NOTE:
You cannot modify the set time during vortexing; however, you can stop the
unit with the START/STOP button and then reset the time.