Connecting Cornered
Installation guide
1. Connect the cables
2. Find the perfect spot
3. Mount the speakers
1. Connect the cables
Note:
It is important that you install the speaker cables BEFORE mounting your new
CORNERED speakers! The speakers are equipped with discreet cable terminals placed
on the front baffle behind the front cover – and it is not possible to run the cables to
the terminals once the speakers have been mounted.
• Remove the front cover to access the cable terminal (the front cover is held in
place with neodymium magnets)
• Make sure the amplifier is turned off
• Run the speaker cable through the tube positioned at the rear of the cabinet
The cable will come out between the woofers on the front plate
• Connect the red plus (+) output from the amplifier to the red plus (+) cable
terminal located to the right of the tube
• Connect the negative minus (-) output from the amplifier to the black minus (-)
input terminal located to the left of the tube
Important notes:
• The tube allows for cables with a maximum diameter of 10mm
• For the best result, use speaker cables with a wire thickness of min. 1,5mm2
• If the red amplifier output is connected to the black speaker input (out of phase),
the stereo imaging will be blurred, and the bass output will be dramatically
reduced
• Make sure the terminals are screwed down tight after connecting the cables
• Always use the same type of cables for left and right speaker channels
When you have connected the cables to the terminals, pull the cables tight in the tube
– and you are ready to mount the speakers.
Getting started
Follow 3 easy steps to install your new
CORNERED speakers, and soon you’ll be
cornered by sound in a class of its own:
2
3
3
1
Remove the front cover
1
2
Run the speaker cable
3
Connecting speaker cables
06
07
Pull grill out
<
Push on side of grill
<
