17
service center authorised by the manufacturer must be contacted in the following cases:
1. If in doubt about the integrity of the appliance after removing it from its packaging
2. If the power supply cord has been damaged or needs to be replaced
3. If the appliance breaks down or functions poorly; ask for genuine spare parts
It is a good idea to note the following:
1. steam cleaner should not be used to clean the oven
2. Only use the appliance to cook food and nothing else
3. Check the integrity of the appliance after it has been unpacked
4. disconnect the appliance from the power socket if it is not functioning properly and before cleaning
or performing maintenance
5. When left unused, unplug the appliance form the power socket
6. Use oven mitts to place or remove cookware in the oven
7. Always grip the oven door handle in the centre as the handles may be hot due to any hot air leaks
8. Make sure the knobs are in the OFF position when the appliance is not in use
9. Remove the power supply cord after disconnecting it from the power supply when you decide not
to use the appliance any longer
10.The manufacturer may not be held responsible for any damage due to: Incorrect installation,
improper, incorrect and irrational use
Only a qualified person in compliance with the instructions provided must be allowed to install the
appliance. The manufacturer declines all responsibility for improper installation, which may harm
persons, animals and damage property.
Important: – the power supply to the appliance must be cut off before any adjustments or
maintenance work is performed on it;
– air duct is supposed to use in ventilation.
INstallatIoN oF BuIlt-IN oveNs
In order to ensure that the built-in appliance functions properly, the cabinet containing it must be
appropriate. The figure below gives the dimensions of the cut-out for installation under the counter or
in a wall cabinet unit.
INSTALLATION
4
Please read the instructions in this owner’s manual carefully before use. keep this instruction manual
for future reference.
ClOsE-Up vIEw
A. Control Panel
B. Cooking mode selection knob
C. Cooking temperature selection knob
d. Electronic programmer-Allows you to programme the desired cooking
duration by selecting the cooking duration and the end cooking time. It can
also be used as a timer (applicable to certain models)
E. Oven indication light (applicable to certain models) - When lit, it indicates
the oven is heating up to the set temperature or the heat plate is heating
according to the heating mode set.
F. dripping Pan or Baking
sheet
G. Oven Rack
H. Guides for sliding the
racks or dripping in and
out
I. End Cooking Time knob
PARTS IDENTIFICATION
CBO-656IX(210311)FA_Layout 1 3/21/11 10:27 AM Page 9