Cornelius ID-90 Series, Инструкция по установке и обслуживанию

Страница: 9 / 14

Landmark Ice Dispenser Installation and Service Manual
© 2004-2014, Cornelius Inc. - 5 - Publication Number: 60418002
T
ROUBLESHOOTING
G
UIDE
The following is provided to aid in correcting ice dispensing system problems. Refer to individual
accessory manuals for troubleshooting help for other components.
WARNING - Disconnect electrical power before attempting any repairs.
PROBLEM POSSIBLE CAUSE SOLUTION
Ice Dispenses Continuously Misaligned door assembly or
solenoid
Adjust solenoid
Misaligned micro switch Adjust micro switch
Ice Dispenser Door will not
close
Ice jammed in chute Adjust bridge or when manually
filling, break up clusters.
Solenoid plunger dragging or
catching
Adjust solenoid.
Dispenser will not dispense
ice
No Power Check electrical connections.
Solenoid Malfunction Replace solenoid.
Dispenser overloaded with ice Remove ice from dispenser
until unit will operate.
Motor not working Replace motor or motor start
capacitor.
Stationary bar is not in correct
location
No ice in bin Fill bin with ice. If field installed
ice maker
in use, turn on or repair.
Gearmotor thermal overload Reset red button underneath
gearmotor.
Excessive Clustering or
Bridging of ice
Loaded ice not broken up Break ice clusters before
manually filling bin.
Extremely low usage of
dispenser
Install bin thermostat to lower
ice level.
Static Bar not in position Reposition, see Figure 1.
Excessive water spilling from
field installed ice maker
Adjust ice maker to eliminate
spillage.
Poorly adjusted field installed
ice maker
Adjust ice maker to eliminate
large waffle shapes.