Cornelius ID-90 Series, Инструкция по установке и обслуживанию

Страница: 7 / 14

Landmark Ice Dispenser Installation and Service Manual
© 2004-2014, Cornelius Inc. - 3 - Publication Number: 60418002
I
CE
G
ATE
A
DJUSTMENT
An ice gate is provided to control the dispensed flow rate of ice. The ice gate is mounted on the
positioning tab at the end of the static bar. The ice gate may be adjusted for the type and size of ice being
used. Once set no further adjustments should be necessary.
Prior to adjusting the ice gate position, be sure to disconnect power to the dispenser to prevent the
agitator from rotating while adjusting the ice gate.
Fill bin with ice up to the chute to a depth of approximately 6 inches from the bottom of the bin. With a cup
held below the ice chute, press the ice dispense button or lever. If the flow rate needs adjustment,
disconnect power and remove static bar assembly (see Figure 2). Reposition ice gate to either the
fast,
medium, or slow position as shown in Figure 1. Carefully reinstall static bar assembly as described in
Figure 1.
C
LEANING AND
M
AINTENANCE
The dispenser must be cleaned and sanitized after installation and, thereafter, as required by state
and local health departments, or every three months minimum.
Continuous maintenance of this unit is a basic requirement for proper operation and sanitation, including
all support equipment utilized in the daily operation of this equipment.
FIGURE 2