Ice Cooled Dispensers Operators Manual
Publication Number: 166239002
- 4 -
© 2003-2010, IMI Cornelius Inc.
Cleaning Dispensing Valves, Post-Mix
1.
Remove the valve cover(s) and wash in plain water.
2.
Remove the nozzle and the syrup diffuser and wash the parts in plain water.
IMPORTANT: When washing the dispensing valve, care must be taken not to get water on
the electrical solenoid.
3.
Hold an appropriate container under the dispensing valve. Being very careful not to get water on the elec-
trical solenoid, slowly pour plain water over the dispensing valve.
4.
Install the nozzle and syrup diffuser on the valve.
5.
Install the valve cover(s).
Clean Dispensing Valves, Pre-Mix
1.
Pour clean water over the valve to rinse away any sticky residue.
2.
Using a small round nylon bristle brush, clean the valve spout with plain water.
3.
Dry the valve with a clean dry cloth.
Clean and Sanitize Ice Bin, Drains and Drip Tray
IMPORTANT: Only trained and qualified persons should perform these cleaning and sanitiz-
ing procedures.
Sanitizing Solution - Household liquid bleech that contains 5.25% sodium hypochlorit concentration, (such
as Hi-Lex or Chlorox).
Prepare the sanitizing solution by mixing 0.5-ounces of household bleech to one gallion of potable water.
This mixture must not exceed 200 PPM of chorine, allowable by the FDA. Use this mixture for all sanitizing
procedures.
1.
Remove all ice from the ice bin and melt any remaining ice with hot water.
2.
Remove ice bin drain strainer by lifting straight up.
3.
Prepare a mild detergent solution in 120
o
F (48.9
o
C) potable water. NEVER use water hotter than 120
o
F
(48.9
o
C).
4.
Using a nylon bristle brush (
Do Not
use a wire brush
), clean the cold plate and the interior of the ice bin
with the detergent solution.
5.
Pour the remainder of the detergent solution down the drip tray and bin drains. Observe that the solution
flows freely. If not, determine the cause. It may be necessary to replace the drain tubing.
6.
Prepare two or more gallons of sanitizing solution. Pour half of the solution down the bin and drip tray
drains. After the has completely drained, pour the remaining solution down the drains.
7.
Replace the drain strainer.
8.
Using a mechanical spray bottle, prepare sanitizing solution and spray the entire interior bin surfaces.
Allow to air dry.
Sanitize Tank Systems, Post-Mix and Pre-Mix
1.
Remove all ice from the ice bin and melt any remaining ice with hot water.
2.
Remove all the quick disconnects from all the tanks.
3.
Prepare a mild detergent soap solution in 100
o
F potable water in a suitable pail or bucket.
4.
Submerge all disconnects (gas and liquid) in the soap solution and then clean them using a nylon bristle
brush (
Do Not use a wire brush
). Rinse with clean water.
