Cornelius Energize6, Руководство по обслуживанию

Страница: 32 / 52

Energize6 Service Manual
Publication Number: 621058457SER - 28 - © 2012, IMI Cornelius Inc.
Figure 29.
R
EPLACING THE
E
LECTRONIC
I
CE
P
ROBE
The electronic ice probe is located in the water bath near the center rear of the unit
To remove and replace the electronic ice probe, perform the procedure in Table 20.
Mounting
Screws
Mounting
Screws
Table 20.
Step Action
1 Turn off the electrical supply to the unit.
2 Remove the cover using the procedure in “Removing the Unit Cover” on page 14
3
Lower the water level of the water bath by removing the overflow tube from
the unit.
4
Thaw the ice bank. This can be accelerated by pouring warm water into the
water bath.
5
Unplug the connector from the control box, making sure to remove any tie
wraps holding the wiring in place.

TIP: Once all tie wraps have been removed, tie a length of string to the
connector before pulling it out of the control board. Then pull the wiring out
of the unit and untie the string. Use the string to fish the new wiring back
through the unit to the control box.
6
Unsnap the ice probe from the evaporator coil and lift the assembly up
and out of the water bath, shown in Figure 30 and Figure 31.
7 Remove the tie wrap from the assembly.
8 Install a new tie wrap to retain the probe to the support clip.
9 Install the assembly back into the water bath.
10
Replace the overflow tube, if removed, being careful to lubricate the O-
rings on the bottom of the tube with water before inserting it into the drain.
11
Reconnect the connector to the control box and replace the cable ties to
keep the wiring away from any hot areas of the unit.
12 Turn on the electrical supply to the unit.
13 When the unit is refilled, replace the unit cover.