ED150 “K” Style Lid Kit Installation Instructions
Publication Number: 92111INS
- 2 -
© 1996-2010, IMI Cornelius Inc.
1.
Unpack kit.
2.
Place insulation strip (item 12) over studs on the ice baffle (item 10) and insert ice baffle into the lid assembly
(item 2).
3.
Place (2) sealing washers (item 9) over studs and (2) flat washers (item 11), then fasten in place with (2) plastic
acorn nuts (item 8).
4.
Set ice maker lid assembly on the top of the dispenser.
5.
Using the slotted holes in the lid as a template, drill four (4) 0.140" diameter (9/64") holes at the bottom of the slots
(see detail A). Use extreme care not to drill into the hopper. Fasten the lid assembly to the dispenser with two (2)
#8 sheet metal screws (item 4), one on each side.
6.
Seal the ice maker to the top of the dispenser as follows:
7.
Run beads of RTV (item 5) around the opening in the lid assembly and inside of the perimeter of the ice maker
outline so that the ice maker will set on the RTV.
A. Set the ice maker onto the lid assembly and position it as required.
B. Wipe away the excess RTV.
8.
Drill 9/64
diameter holes into the ice maker cabinet using the bracket (item 3) as a template. Use extreme care
not to drill into any ice maker components (condenser, tubing, etc.). Secure the brackets using four (4) #8 sheet
metal screws (item 4).
9.
Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the bin ther-
mostat if so equipped or required.
10. If the plastic ac or rn nuts interfere with the positioning of the plastic manual fill cover, it may be necessary to make
small notches in the back flange of the cover to clear the acorn nuts.
CAUTION:
!
Bin Thermostat must not interfere with the agitator rotation.
