Cornelius DPC 230, Инструкция по установке и обслуживанию

Страница: 16 / 27

161952801
14
6. Remove drain screen from inside the ice bin.
7. Remove two screws securing the sink top, then remove sink top from the station tub.
8. Remove three screws securing the ice chute and the ice chute back from the upper bin section.
9. Remove grille from the station tub.
10. Using three clean five gallon pails, fill the first pail with approximately three gallons of warm potable water.
Fill the second pail with approximately three gallons of a water/detergent soap solution. Using the third pail,
prepare three gallons of sanitizing solution by mixing 3 gallons of 70
°
F to 100
°
F (max) potable water with
.067ounce sanitizer/gallon water. This mixture will provide 200 ppm of chlorine.
11. Using a plastic bristle brush and the water/detergent soap solution, scrub all parts removed in preceding
steps 1 through 8 (ice bin hopper top cover, stainless steel breaker bar, ice rotator, sink top, ice chute, ice
chute back, grille, and all screws), then rinse all parts in clean water and allow to air dry.
12. Scrub ice bin hopper top rim, ice bin hopper interior, ice bin hopper discharge opening outer surfaces, and
sink with the water/detergent soap solution, then rinse with clean water.
13. Clean all external surfaces of the dispenser with a sponge and water/detergent soap solution. Rinse out
sponge with clean water, then wring excess water out of the sponge and wipe off all external surfaces of
the dispenser. Wipe dispenser dry with a clean soft cloth. DO NOT USE ABRASIVE-TYPE CLEANERS.
14. Place all small removed parts in the sanitizing solution and allow them to soak for ten to fifteen minutes
(ice bin hopper top cover, stainless steel breaker bar, ice rotator, sink top, ice chute, ice chute back, grille,
and all screws).
15. Using a plastic bristle brush and the sanitizing solution, scrub the ice bin hopper top cover, stainless steel
breaker bar, ice rotator, sink top, ice chute, ice chute back, grille, and all screws and allow to air dry.
16. Install drain screen, stainless steel breaker bar, ice rotator, ice chute and ice chute back, sink top, and
grille on the dispenser by reversing removal procedures.
17. Fill the ice bin hopper with ice as instructed in FILLING DISPENSER ICE BIN HOPPER in the
INSTALLATION section of this manual.
18. Install ice bin hopper top cover.
19. Restore electrical power to the dispenser.
20. Test dispense the dispenser for proper operation.
ADJUSTMENTS
Refer to ADJUSTMENTS in INSTALLATION section of this manual for all adjustment instructions that may be
performed on the dispenser.
FILLING DISPENSER ICE BIN HOPPER
Refer to FILLING DISPENSER ICE BIN HOPPER in INSTALLATION section of this manual for instructions to
fill the ice bin hopper with ice.