Cormach MEC 1, Техническое руководство по обслуживанию

Страница: 10 / 19

Technical Support Manual – 05/2015 Rel. 0 Page 8
SPn

Revolution counter reset (spin)
This menu option allows you to reset the machine revolution counter.
Figure F3.5:
Revolution counter reset message
Confirm to reset the revolution counter (the LH display will show
yEs
). Press [F+P5] to confirm or any other key
to cancel the operation.
The revolution counter counts only the revolutions performed in NORMAL mode. A manually blocked revolution (using the STOP key
or the wheel guard) will not be counted.
4. PICK-UP SPRING PRE-CHARGE REGULATION
Equipment required: 6 mm hex wrench.
To function properly, the pick-up must be pre-charged with a spring. In order to do so, the spring must be compressed with a screw
according to that described below:
1. Manually tighten the hex screw until it stops;
2. Repeat step 1 for the other pick-up;
3. Make sure that the springs and hex screws are perpendicular to the pick-up support unit. If required, loosen the screw, turn
the spring (or invert it) and repeat steps 1 and 2 until you obtain perpendicularity;
4. Tighten the screws of the two pick-ups by turning three times. It is good practice to perform one turn at a time, alternating
the two pick-up springs. See figure F5.1;
5. Calibrate the machine.
IMPORTANT: Each time a pick-up is tightened or loosened, the machine MUST always be calibrated.
Figure F4.1: Pick-up spring pre-charge regulation
3 turns