7
Installation Guide
Corinex AV CableLAN Adapter
2.5
Testing the Setup
To verify that the connection is working correctly, use the standard
Ping
utility. In Windows,
click on menu
Start -> Run
, then write the command
ping IPADDRESS -t
, where IPADDRESS
is the IP address of the computer to which the AV CableLAN Adapter is connected to, e.g.
ping 192.168.4.1 -t
(This command will be stopped by pressing keys
CTRL+C
).
• Ping the IP address of the computer to which the AV CableLAN Adapter
is connected. If this fails, there is a problem with the Ethernet network card or
with the TCP/IP protocol.
• Repeat the same process with the other computers on the cable network.
• If all computers can ping themselves, try pinging another computer on the cable
network. If this fails, there is a problem with connections on the cable. Try to
check the connection to the cable network or use a different socket.
• If the setup does not work refer to the troubleshooting guide, but first, try
unplugging the AV CableLAN device and reboot the computer as this sometimes
fixes the problem.
NOTE:
In a Corinex AV CableLAN network, you can have up to 62 devices. One of
them has to be switched to master mode, others to the slave mode. For setting up
a master device, please set the switch 1 to the “Lo” position. For all other devices,
please set the switch 1 to the “Hi” position”. After this setting, power cycle the
devices to enable the new functionality.
