Corghi A 2005, Руководство оператора

Страница: 37 / 180

A 2030 - A 2025 - A 2020 - A 2015 - A 2005
operator’s manual 37
GB
- Insert the air hose G fig.2 into hole A behind the tower tilt cylinder.
- Fit screw B into hole C and lock with nut and washer D.
- Insert pin E into hole F and into U-bolt F1 on the tower tilt cylinder and lock with snap-
ring M.
- Connect hose G to the intermediate connection linked to the tower-lifting cock.
- Open the bead break arm Z.
- Insert the spacer pad U on to the bead break cylinder pin V, re-close the bead break
arm by passing the bead break cylinder pin back through the adjustable outlet.
- Nut T is to be screwed on to bead break cylinder pin V only when the machine is in-
stalled and hooked up to the compressed air line. Tighten nut T until P is 3-4 mm. For
the A2030 only, tighten the nut and locknut until P is 20 mm.
- Fit the tower guard 2 and lock with screws and washers L.
- Fit the side cover.
A 2005
- After removing the tower 1, it is advised to place it in a horizontal position to prevent
it from falling and getting damaged.
- Assemble the tower 1, insert pin B into hole C and lock with screw and washer D.
- Insert pin E into hole F and into U-bolt F1 on the tower tilt cylinder and lock with ring
M.
- Open the bead break arm Z.
- Insert the spacer pad U on to the bead break cylinder pin V, re-close the bead break
arm by passing the bead break cylinder pin back through the adjustable outlet.
- Nut T is to be screwed on to bead break cylinder pin V only when the machine is in-
stalled and hooked up to the compressed air line. Tighten nut T until P is 3-4 mm. For
the A2030 only, tighten the nut and locknut until P is 20 mm.
- Fit the tower guard 2 and lock with screws and washers L.
HOISTING / MOVING
To remove the machine from the pallet, sling it as shown in figure 3.
This lifting point must be used whenever you need to change the position of the machine.
Do not attempt to move the machine until it has been disconnected from the electrical
and air networks.
INSTALLATION CLEARANCES
WARNING
Choose the place of installation in strict observance of local regulations regarding
safety in the workplace.
IMPORTANT:
for correct, safe use of the equipment, users must ensure a lighting level
of at least 300 lux in the place of use.