Core CHT 410, Руководство по обслуживанию

Страница: 15 / 16

1. Place the 5/8” bolt through the shaft clamp hole
on the rear of handle, and the 3/4” bolt through
the shaft clamp on the front part of the handle.
Using the T25 bit, tighten the shaft clamps so the
grip handle is snug to the shaft.
2. Place the lockout lever on the post as shown in
picture 2, with the spring pre ‐ loaded.
3. Place the Trigger down on it’s post with the
spring preloaded, as shown in picture 3.
4. Route wire back to Power Housing and plug wire
connector back into Controller.
HARDWARE AND PARTS REQUIRED:
‐ RIGHT SIDE OF RH GRIP “B”
‐ (2) SHAFT CLAMPS
‐ (2) 10 ‐ 32 5/16 NUT
‐ (1) 10 ‐ 32 ¾ BOLT
‐ (1) 10 ‐ 32 5/8 BOLT
‐ (4) RIGHT HAND GRIP SCREW
‐ TRIGGER
‐ TRIGGER SPRING
TOOLS:
‐ (2) ELECTRIC/SCREW GUN, T25 AND T18 BITS
Power Housing / Grip Handle Assembly
3 . 2 .
1 .