Core Lighting StripPoint, Руководство пользователя

Страница: 15 / 23

StripPoint User Manual rev.1_0 13
Pairing a StripPoint slave to a W-DMX Transmitter unit or CORE Master unit

Switch on the StripPoint Slave and ensure it is in DMX Slave Mode (see above DMX Slave
Operation).

Ensure the StripPoint is unpaired from any other transmitter (i.e. the LINK LED is OFF)
– above
Unpairing a Slave fixture from W-DMX Transmitter Units.

Ensure the transmitter is within range and switched on.

On most W-DMX transmitters (including CORE ColourPoint and StripPoint units) press the
button on the master for about 1s.

The transmitter will scan for all unlinked receivers for around 10 seconds; the LED will flash on
the Slave and Master units during the process of pairing.

If pairing is successful the LINK LED on the Slave StripPoint will illuminate permanently.

ALL Unlinked StripPoint units (and other Unlinked W-DMX units too) may be linked at the same
time. No apparent limit to the number being paired.

For receiver units not to be paired with this transmitter, simply switch off those unwanted
receivers before this pairing process. They may be paired with a different transmitter after
switching on again and repeating the pairing process with the new transmitter.
Pairing with a CORE Point15, Point20 or Point30 Master unit

Switch on the StripPoint.

Ensure the StripPoint is unpaired from any other transmitter (the LINK LED is OFF)
– above.

Ensure the Master unit is within range and switched on.

Select MODE MSTR

MSTR DMX

Add Unit
 ‘+’ to select ‘YES’ 
to confirm.

The transmitter will scan for all unlinked receivers for around 10 seconds; the LINK LEDs flash.

If pairing is successful the LINK LED on the StripPoint will illuminate.
For successful linking the receiver must fulfill the following conditions:
Distance to transmitter (in free air)

Less than 200m for Micro model transmitter

Less than 500m for BlackBox or WhiteBox transmitter
Position above obstacles (e.g. crowds and tress)

Minimum 1m
Pairing a StripPoint Master to other fixtures

Ensure the fixtures to be controlled are in SLAVE mode and unlinked (the LINK LED is OFF
–
above.)

Ensure the Master unit is within range and switched on.

Press the button for about 1s and the W-DMX led will flash indicating that it is scanning for
Slave fixtures. On completion the led will stay on solidly and will glow permantly on the linked
Slave fixtures too.
i
Pairing to a transmitter is remembered after power off or the battery is depleted.
This allows the system pairing to be set up in a warehouse and the whole system simply switched on at
the site, which makes deployment very simple.