4. Connection to Power Supply: Power off your
original pump/ wave maker DC adapter, and then
connect to AQLink A1 DC jack input, the jack polarity
is as below:
5.
Finally, switch on the input power of the DC
adapter, the green LED will light up indicating the unit
start to operate normally.
(Fig.4 Programming Switch Setting for Supported Pumps sample)
1
DCA2000
DCS2000
2
DCA3000
DCS3000
DCA3000
DCT3000
3
DCP3000
4
DCS4000
DCT4000
5
DCP4000
6
DCP5000
7
DCA6000
DCW6000
DCS6000
DCQ6000
8
DCP6500
9
DCS7000
10
DCP8000
DCT8000
11
DCS9000
12
DCP10000
13
DCS12000
DCT12000
14
DCT15000
15
CP-25
CP-90
16
CP-40
CP-120
17
QP-9
18
QP-16
19
Reversed
20
GF150
Warning
Precaution – Controller Installation
Please install the controller
AWAY from wet, high humidity
and hotenvironment
,excessivehumidityand high temperature
operating environment may
DAMAGE THE CONTROLLER PERMANENTLY
Pleaseinstallinanenvironmentwithgoodventilation.This is to
allow the internal electronics working at the desired temperature
and operating environment, or else product durability will be
affected. Active ventilation is required when the operating
temperature is high
All right Reserved – No part or whole of this Manual can be reproduced without written
authorization by Coral-Box.com
