COPLAR EA-LG-01, Руководство оператора

Страница: 8 / 11

- 8 -
A
SSEMBLY
The edger attachment is fully assembled at the factory and requires no further assembly.
JONING THE POWER HEAD TO THE EDGER ATTACHMENT
See Figure 2.
The edger attachment connects to the power head by means of a coupler device.
1.
Loosen the knob on the coupler of the power head shaft and remove the end cap from the edger
shaft.
2. Push in the button located on the edger attachment shaft. Align the button with the guide recess on
the power head coupler and slide the two shafts together. Rotate the edger attachment shaft until the
button locks into the positioning hole.
NOTE: If the button does not release completely in the positioning hole, the shafts are not locked into
place. Slightly rotate from side to side until the button is locked into place.
3.
Tighten the knob securely.
REMOVING THE ATTACHMENT FROM THE POWER HEAD
For removing or changing the attachment.
1.
Loosen the knob.
2. Push in the button and twist the shafts to remove and separate ends.
WARNING :
Never attach or adjust any attachment while power head is running. Always stop the unit and remove the spark
plug wire or disconnect from the power supply. Failure to heed this warning can cause serious personal injury.
WARNING :
Be certain the knob is fully tightened before operating equipment; check it periodically for tightness during use
to avoid serious injury.