20
Network Camera User Manual
1. Check “Enable” and then click “Draw Area” button.
2. Drag the mouse to set the ROI area.
3. Set the level.
4. Click “Save” button to save the settings.
Now, you will see the selected ROI area is clearer than other areas especially in low bitrate
condition.
4.3
PTZ Configuration
The PTZ of this camera can be controlled by the keyboard. Connect the keyboard and the
camera through RS485 interface and then set the corresponding protocol and baud-rate in the
camera and keyboard.
Go to PTZ
Protocol interface as shown below.
Here the protocol and baud-rate must be the same with these of the keyboard.
Address: 1; you can control PTZ channel 1 by using this address in the keyboard.
Address: 2; you can control PTZ channel 2 by using this address in the keyboard.
……
