13
1-6-4 Network Configuration
1. Select Enable or Disable to enable/disable remote monitoring.
2. Click Up & Down buttons for IP, NetMask, GateWay adjustment; click
Set when ready.
Note: Please consult the instructions provided with a COP Remote View &
Playback package or your Internet Service Provider for the relevant information.
3. Click on the red disk icon on the top right corner to save the setting.
4. Reboot DVR by turning off the power and switching on again
(A password for remote monitoring is required. Refer to section 1-6-6 for
password setting).
1-6-5
、
DI/DO (Direct input and output)
1
DI/DO supports 4 inputs and 4 outputs.
2
DI control options:
2.1 Disable: not used.
2.2 NC (normal close): signal loop is normally closed; if loop
becomes open, then LINUX MPEG4 Security Video Server
starts to record.
2.3 NO (normal open): signal loop is normally open; if loop becomes
closed, then LINUX MPEG4 Security Video Server starts to
record.
3
DO control options:
3.1 Disable: disable the output signal.
3.2 Enable: enable the output signal. The signal duration can be
set to 0.1, 0.5, 1, 2, 5, 10, 20, 30, and 60 minutes.
4
Click on the red disk icon on the top right corner to save the setting.
