CF 52A
2
Mar 2014
1.3 Layout
Figure 1-1
Chapter 2 - Installation/Setup
2.1 Wiring
WARNING: CONNECT ALL WIRES PRIOR TO APPLYING POWER TO
THE AMPLIFIER. FAILING TO DO SO CAN RESULT IN DAMAGE TO THE
AMPLIFIER!
Use an 18-32 V single voltage supply to power the DCM 495. Strip the cables back 2-3 inches with the
wires stripped and tinned ½”. Connect as shown in the following diagrams: Figure 2-1 shows the
connection between the transducer and the DCM 495 and Figure 2-2 shows the power supply connection
to the inline amplifier and the signal connection to a data system readout. Observe the wiring code of the
transducer to ensure proper connection. Connect the stripped and tinned wires to the terminal block inside
the DCM 495 by pressing the orange levers and inserting the wire inside the hole next to the lever.