18
jamming, or if parts are damaged. Every part must be correctly fitted and must satisfy
all the requirements necessary to guarantee trouble-free operation of the power tool.
Damaged protective devices and parts must be properly repaired or replaced by a
recognised specialist workshop, except where detailed in the operating instructions.
20. Attention
Only use accessories or add-on units specified in the accessory list of the operating
instructions. Only use WELLER accessories or add-on units on original WELLER
equipment. The use of other tools and other accessories can mean that you run the risk
of injury.
21. Have your power tool repaired by a qualified electrical specialist.
This power tool complies with the appropriate safety regulations. Repairs may only be
carried out by a qualified electrical specialist using original WELLER spare parts;
otherwise accidents can result for the operator.
22. Use with other WELLER equipment.
If the power tool is operated in conjunction with other WELLER units or add-on units,
the warning information contained in their respective operating instructions must also be read.
23. Observe the safety regulations applicable to your workplace.
Safety instructions
The manufacturer accepts no liability for usage other than that specified in the operating
instructions, nor for any unauthorised modifications.
These operating instructions and the warning information they contain should be read
carefully and kept in a clearly visible place adjacent to the soldering unit. Failure to
adhere to warning information could cause accidents and injuries or be detrimental to
health.
The WELLER WFE P soldering fume extraction unit complies with the EC certificate of
conformity in accordance with the basic safety standards of EC guidelines 89/336/EEC,
73/23/EEC and 89/392/EEC.
2. Description
The Weller WFE P is a fume extraction device for one or two Weller FE soldering
irons.
The unit is best suited to continuous industrial operation in the workplace due to its
maintenance-free pump drive and low noise generation. The vacuum hoses of the FE
soldering bits are connected directly to the WFE P soldering fume extraction unit. A
built-in thermal cut-out protects the unit against overload. A built-in lifting device for
changing the filters allows trouble-free replacement of the filter cartridge and preliminary
filters without the aid of tools.
The 3-stage filter installed, comprising fine particulate air filter F7, Class H13 particulate
filter and wide band gas filter (50% activated carbon; 50% Puratex) is ideally suited in
this configuration to the extraction of soldering fumes. The particulate filter and the
gas filter are contained in the main filter cartridge. Both filter elements are disposable
filters and the fine particulate air filter (preliminary filter) can be changed several times
before the main filter cartridge has to be replaced.
Warning: When using extraction equipment, the legal limits with regard to contaminants
in the workplace must be observed and regularly checked by the operator of the
extraction equipment.
Technical data
Mains voltage:
230V AC
Power consumption:
50W
Max. vacuum:
30.000 Pa
Max. carrying capacity:
30 l./min.
Noise level:
40 dB(A) at 1m intervals
Protection category:
1
Dimensions:
140 x 295 diameter x height
Capacity:
max. 2 FE soldering irons
3-stage filter:
Fine particulate air filter F7
Class H13 particulate filter
Wide band gas filter: 50% activated carbon, 50% Puratex
WFE P (2)
21.03.2003, 8:51 Uhr
18
