12
Clamp Specific Operating Instructions
(continued)
"GXRPC" Clamp
1.
Press down on the shackle to retract the cam. Place
clamp squarely on plate to the full depth of throat
opening. Release shackle so that cam engages plate.
You are now ready to make the lift.
2.
To release plate, press down on the shackle and lift
clamp off plate. If cam sticks, however, a slight tap on
the shackle will release it.
“Horizontal Plate” Clamp
At least two of these clamps are to be used in
a lift. The sling angle between the sling legs must not
exceed 60°. Sling legs must be of equal length.
The 6 T working load limit is per pair of
clamps.
The plate or plates must not sag or buckle
when lifted using these clamps. These clamps are to be used
for lifting in the horizontal position only.
1.
Pull back cam and install clamp on plate or plates so that
the plate or plates are fully inserted into the jaw opening.
After all the horizontal plate clamps to be used are
installed on plate, you are ready to lift.
2.
After the plate or plates are at rest, pull back on cam to
remove the clamp from the plate.
Angle of lift
should not be
less than 60°
60°
WARNING:
WARNING:
WARNING:
