9752 Installation Guide
1. Introduction
497098 Issue 3
Page 5
9930 and 9940 Keypads
A
B
C
D
1
2
3
4
5
6
7
8
9
0
Figure 2. 9930 and 9940 Keypads
The control unit supports the connection of 9930 and 9940 keypads. The
9940 is the later replacement for the 9930, and offers smaller size, a built-in
wide-area proximity reader and connections for an external panic alarm
switch. Both have a two-line 16-character Liquid Crystal Display (LCD) that
can display alarm information, programming settings and other information.
There are three LEDs that have the following functions.
Note: Depending on how the system is set up, the LEDs may not operate until
a user code is presented.
Alert lamp – Flashes to highlight unacknowledged alert, glows for
acknowledged conditions, and goes out when all conditions have
been rectified.
s
Service lamp – Glows if the system needs an installer reset.
a
Mains lamp – Glows when using mains power. Flashes when using
the stand-by battery.
ScanProx Proximity Tag Reader
The ScanProx 934EUR-50 proximity reader module enables you to convert
9930 keypads into proximity tag readers. The module fits onto connector pins
on the keypad PCB, near the display module (Figure 7).
Once the ScanProx module is fitted, users can operate the alarm system by
presenting a tag to the front of the keypad instead of keying in an access
code.
9930 Keypad
9940 Keypad
