2
LRM – iLumin SC Panels
www.cooperlighting.com
Wiring Information
1.
Ensure that the lighting panel is fed from an
emergency circuit.
2. Connect the LRM’s yellow and purple low voltage wires
into the provided terminal block. To force all relays ON,
connect to the ON and +24V position. To force all relays
OFF, connect to the OFF and +24V position. Yellow and
purple wires are not polarity sensitive.
3. Connect the LRM to the normal power monitoring
circuit. Wire the neutral wire to the white wire. Wire
the hot to the colored wire: Brown = 347 VAC.
Wiring Diagram
LRM – iLumin SC Panels
ote:
N
The iLumin SC panel must be fed an emergency
power source in order for the LRM to operate
properly.
IMPORTANT: Line voltage input to the LRM must be
from the NORMAL power source.
Mounting Information
The LRM is shipped in its own enclosure. It is
recommended that the LRM enclosure be mounted below
the lighting panel enclosure and connected through conduit
for the low voltage wire connection into the iLumin SC
panels contact closure terminal.
Wiring Information
1.
Ensure that the lighting panel is fed from an emergency
circuit.
2. Connect the LRM’s yellow and purple low voltage wires
into the provided contact closure terminal block. Yellow
and purple wires are not polarity sensitive.
3. Connect the LRM to the normal power monitoring
circuit. Wire the neutral wire to the white wire. Wire
the hot to the colored wire: Brown = 347 VAC.
4. Program the contact closure input on the lighting panel
as follows using the onboard interface:
i.
From the Configuration menu, highlight the
“Contact Inputs” option and press the
ENT
button.
The display will show the current settings for the
first input:
ii.
Use the
or
buttons to advance the
screen until the correct input number is shown.
Highlight the “Open” option and press the
ENT
button.
iii. Highlight the option to “Exit Emergency State” and
press the button.
iv. Highlight the “Close” option and press the
ENT
button.
v.
Highlight the option to “Enter Emergency State”
and press the
ENT
button.
vi. Program the outputs to respond to the emergency
scene. From the Configuration menu, highlight
the “Emergency Scene Edit” option and press
the
ENT
button. The display will show a list of the
configured Output settings:
On
Connector on Mother Board
Yellow (18AWG)
NC
NO
SPDT Relay
Neutral = White
To Normal Power Circuit
347VAC = Brown
To override ON:
Connect Dry Contact Between on
Override and +24 VDC. When
contact Closes, All Relays Are
Forced ON. Contacts Will Close
When Normal Power is Lost.
Violet
(18AWG)
C
Off
+
Cooper Lighting
Solutions
