45
Installation and Maintenance
Service Manual
Steps
Procedure
6. Remove grille
Remove the 4 screws connecting the grille
and outer case, and then remove the panel
grille.
Remove screws connecting outer case and
motor support, middle isolation sheet and
chassis, pull the outer case upwards slightly,
loosen clasps between outer case and left
side plate, and then remove the outer case.
a.Remove the grounding wire screw on
the electric box assy and then remove the
grounding wire.
b.Disconnect the wiring terminals of
compressor, high pressure switch, compressor
overload protector, temperature sensor,
outdoor fan motor and 4-way valve.
Note:
keep pressing the circlip when disconnecting
the wiring terminal of reactor; keep pressing
the retainer when disconnecting other wiring
terminals.
c.Remove the wire inside the wiring groove.
7. Remove outer case
8. Remove electric box assy
Electric box assy
Outer case
Grille
