Cooper & Hunter CH-S09FVX, Руководство по обслуживанию

Страница: 36 / 80

3
3
Installation and Maintenance
Service Manual
4. Installing Indoor Unit
4-1.Preparation
●Open the front panel, remove the 4 screws and dismount
the front grille while pulling it forward.
●Follow the arrows to disengage the clasps on the
front case to remove it.
●Follow the procedure below when removing the slit portions.
■For Moldings
●Remove the pillars. (Remove the slit portions on the
bottom frame using nippers.)
■For Side Piping
●Remove the pillars.
(1) Remove the 7screws.
(2) Remove the upper casing (2 tabs).
(3) Remove the left and right casings (2 tabs on eachside ).
(4) Remove the slit portions on the bottom frame and
casings using nippers .
(5) Return by following the steps in reverse order(3>2>1).
4-2.Installation
●Secure using 6 screws for floor installations.(Do not forget to secure to the rear wall.)
●For wall installations, secure the mounting plate using 5 screws and the indoor unit using 4 screws.The mounting plate should be
installed on a wall which can support the weight of the indoor unit.
(1) Temporarily secure the mounting plate to the wall, make sure that the panel is completely level, and mark the boring points on the
wall.
(2) Secure the mounting plate to the wall with screws.
Front panel
Open the front panel
Remove
front grille
Casing
Front
grille
Remove 4 screws
3 tabs
3)Side
casings
2)Upper casing
3)Side
casings
Remove the pillar
Remove 7 screws
Casing
Remove the pillar
Casing
Remove the pillar
Bottom frame
6screws
Casing
6screws
Molding
200mm
Floor Installation Wall Installation