Cooper & Hunter CH-S09FTXC, Руководство по обслуживанию

Страница: 13 / 42

21 20
Installation Manual Installation Manual
7.3 Installation Indoor Unit
Step 1: Choosing installation location
Recommend the installation location to the client and then confirm it with the client
Step 2: Install wall-mounting frame
1. Hang the wall-mounting frame on the wall; adj ust it in horizontal position with the level meter and then point out the screw fixin
holes on the wall .
2. Drill the screw fixing holes on the wall with impact drill (the specification of drill head should be the same as the plastic
expansion particle) and then fill the plastic expansion particles in the holes.
3. Fix the wall-mounting frame on the wall with tapping screws (ST4.2X25TA) and then check if the frame is firmly inatalled by
pulling the frame.If the plastic expansion particle is loose, please drill another fixing hole nearb .
Step 3: Open piping hole
1. Choose the position of piping hole according to the direction of outlet pipe. The position of piping hole should be a little lower
than the wall-mounted frame, shown as below.
2. Open a piping hole with the diameter of Ф55 on the selected outlet pipeposition.
In order to drain smoothly, slant the piping hole on the wall slightly downward to the
outdoor side with the gradient of 5-10°.
indoor outdoor
5
～
10
°
Ф55
Note:
● Pay attention to dust prevention and take relevant safety measures
when opening the hole.
● The plastic expansion particles are not provided and should be
bought locally.
Step 4: Outlet pipe
1.The pipe can be led out in the direction of right, rear right or left. 2.When select leading out the pipe from left or right, please cut
off the corresponding hole on the bottom case.
7.2 Installation Dimension Diagram
09
K/12
K
18
K
24
K