Cooper & Hunter CH-S07GKP8, Руководство пользователя

Страница: 10 / 39

Swing button
4
Press this button to set up & down swing angle.
8
Note:
● After putting through the power, the air conditioner will give out a sound.
Operation indictor " " is ON (red indicator,the colour is different for different
models). After that, you can operate the air conditioner by using remote controller.
● Under on status, pressing the button on the remote controller, the signal icon " "
on the display of remote controller will blink once and the air conditioner will give
out a “de” sound, which means the signal has been sent to the air conditioner.
● Under off status, set temperature and clock icon will be displayed on the display
of remote controller (If timer on, timer off and light functions are set, the corre-
sponding icons will be displayed on the display of remote controller at the same
time); Under on status, the display will show the corresponding set function icons.
On/Off button
1
Press this button to turn on the unit. Press this button again to turn off the unit.
● This is a general use remote controller, it could be used for the air conditioners
with multifunction; For some function, which the model doesn't have, if press
the corresponding button on the remote controller that the unit will keep the
original running status.
Introduction for buttons on remote controller
Turbo button
Under COOL or HEAT mode, press this button to activate / deactivate the Turbo
function.
2
Mode button
3
Each time you press this button,a mode is selected in a sequence that goes from
AUTO, COOL, DRY, FAN, and HEAT *, as the following:
AUTO COOL DRY FAN HEAT
*
* Note: Only for models with heating function.
Press this button to start I FEEL function and " " will be displayed on the remote
controller. After this function is set, the remote controller will send the detected
ambient temperature to the controller and the unit will automatically adjust the
indoor temperature according to the detected temperature. Press this button again
to close I FEEL function and " " will disappear. When I FEEL function is turned on,
the remote controller should be put within the area where indoor unit can receive the
signal sent by the remote controller.
5
I Feel button