Cooper & Hunter CH-HP20CMFNM, Руководство пользователя

Страница: 11 / 32

Circulating Air Source Heat Pump Water Heater
6
3 Installation requirement for the unit
Caution:
（
1
）
Improper to operate the unit at the places where there’s strong magnetic field, much salt and
alkali, high acid and unstable voltage.
（
2
）
Confirm the correct transmit path and method for preventing damage and accident.
（
3
）
Confirm whether the installation base is solid. When this unit is installed at the metal part of the
building, it must be electric insulated and comply with related technical standard.
（
4
）
Please make sure the installation position is far away from the storage areas of inflammable
and explosive objects to prevent explosion or fire hazard.
3.1 Before installation
Before installation, the user should open the carton box to check the unit:
（
1
）
Check whether all documents and accessories are complete according to the packing list.
（
2
）
Check the model and specification of the unit basing on the attached documents.
（
3
）
Check whether the unit is in good conditioner and whether the accessories are complete.
（
4
）
Check there’s refrigerant leakage.
（
5
）
If there’s damage or problems, please contact appointed local office of our company in time.
3.2 Position before installation
（
1
）
The unit can be installed on balcony, roof, special flat form or any other places where’s
convenient for installation and bear the weight of the unit.
（
2
）
The unit should be installed the well-ventilated place, and avoid the air discharge and noise
disturb other people. Please pay attention to the wind direction and avoid the strong wind.
（
3
）
When placing the unit on the roof, please pay attention to the wind direction to prevent strong
wind.
（
4
）
There should be no strong thermal source, discharge outlet of other equipments, hot steam and
inflammable gas around the unit.
（
5
）
There should be discharge ditch or discharge outlet nearby the installation position of the unit.
3.3 Movement and installation of the unit
Every unit has been conducted strict test and inspection before ex-factory
for ensuring its specification and quality. User must be careful during installation
and movement to avoid damaging the control system and pipeline parts.
（
1
）
Please adopt fork truck or crane for movement.
（
2
）
Use the canvas gallus or the wire cable with enough strength (
＞
Φ10)
for handing the unit. Wind the base of the unit with the canvas gallus or the wire
cable and then bundle it tightly, and add protective gasket at the contacting
position between the canvas gallus or the wire cable and the unit for preventing
damage to the unit. When moving the unit, the inclined angle should be less
than 15° and the unit should be moved carefully.
（
3
）
After movement is finished, please remove the underlaid gasket,
gasket of compressor.