Cooper & Hunter CH-3040, Инструкция по эксплуатации

Страница: 8 / 20

6. OPERATION OF THE UNIT
6
Pressing this button again sets the device to an average evaporation
rate — the second concentric circle lights up at the top of the display.
To set the maximum evaporation rate, press the button a third time.
Pressing it again will return you to the minimum level of evaporation. The
button “Setting the humidity level in the manual mode” works only when
the Manual mode is selected.
1. Air humidifier - 1 pc.
2. Brush for cleaning membranes - 1pc.
3. Operation manual - 1 pc.
4. Filter - 1 pc.
5. SCOPE OF DELIVERY
• Automatic mode / Child mode (12):
It is a button for selecting one of four mutually exclusive modes of
operation. Press this button to switch the instrument to Automatic
mode. The evaporation rate in this mode is presented in Table 2.
Repeated pressing of this button takes the device to Children’s mode
with a preset humidity of 55%, recommended for young children. If you
want to return to Automatic mode, click this button again.
Humidity Evaporation rate
before 40% Maximum
40%-60% Average
over 60% Minimum
Table 2
• Night mode (11):
It is a button for selecting one of four mutually exclusive modes of
operation. Press this button to reset the instrument.
went to the SMART night mode. If within 5 seconds after pressing this
button you do not perform any actions, the device switches to Night
mode, the display of the device turns off, and only the corresponding
indication remains on.
In this mode, the timer will automatically turn on,
set to 8 hours. The evaporation rate in this mode is shown in Table 2. If
any button is pressed in the SMART Night mode, except “On / Off”, the
Hygrometer will show the current humidity in the room, then after 5
seconds the Display will turn off again. Double pressing of the button
“Manual mode / Evaporation rate” or “Automatic mode / Child mode”
will activate another mode. Pressing the “On / Off” button will turn off the
instrument. When you turn on the settings again, you will need to set it
again.
• Ionization (10)
This button includes an ionizer that compensates for the lack of
negatively charged ions (anions) in the air.
Anions strengthen the nervous and circulatory systems, improve lung
function and provide protection against respiratory diseases (such as
pneumonia and asthma).
• Automatic shutdown in case of insufficient water level (5):
This indication lights up when water is running out in the device. To
avoid overheating of the ultrasonic membrane, the device shuts off
automatically.
1. Holding the handle, remove the water tank from the device (see fig. 1)
2. Turn the water tank upside down and unscrew the tank lid by turning it
counterclockwise.
NOTE:
The filter cartridge is attached to the water tank cap. If you
are not going to use the filter, you should remove it by
turning it counterclockwise.
3. Pour clean water into the tank. For this model it is recommended to
use demineralized water. Do not over-fill the tank! After filling, close the
tank cap, turning it clockwise.
4. Place the tank back into the device.
NOTE:
Do not pour water into the base of the device - it may fall
into the hole for overflow, and the surface under the device
becomes wet.
An overflow hole is provided in order to eliminate the risk of
water entering the electronic components of the device
through an air-blowing hole (Fig.2).