Revised: 13/10/2015
PPPrintew
- 13 -
13 of 19
- 13 -
Printed: 14/10/2015
I
NSTALLATION OF
L
OG
S
ET
1.
Place the rear log on the rear of the burner plate as shown.
2.
Place front log on the front section of the burner.
3.
Fit the cross logs (as illustrated below) to the pins located on the front and rear logs
4.
The small logs supplied are for fitting into the gaps in the front corners of the burner assembly.
Care should be taken not to place these over the burner holes. Logs should not touch the sensor or
sparker.
Above diagram shows correct orientation of logs
WIRING DIAGRAM
G
AS
V
ALVE
A
DJUSTMENT
The gas valve pressure adjustments must be checked during installation, and if necessary corrected to
suit the gas type available. (See label inside of lower cover panel or this page for required pressure
settings).
