Coolzone CZ51063, Инструкция пользователя

Страница: 4 / 16

Page 4
Installation
Positioning the appliance
When deciding on a location for the appliance, please
bear the following points in mind:
• The depth of the unit from front to back is roughly
the same as the majority of work surfaces. This
means there is not enough room for any pipes etc.
to be positioned at the rear of the unit. To facilitate
this, the dishwasher is designed with the water
supply and drain hoses positioned to the right and
left for correct installation. The back rests against
the wall.
• The lower plinth for the kitchen base units will need
to be removed for installation.
• The minimum dimensions of the space required for the appliance are shown in
Figure 2.
• Level the appliance by the adjustable foot (Figure 3).
Provision for the connections
The connections for the appliance are shown in Figure 4 and Figure 5.
Drain hose connection
When routing the drain hose, avoid bending or crimping it. Use the plastic hose guide
that comes with the appliance ensuring that it is securely fastened to the wall.
You can either let the drain hose empty straight into the sink, connect it to a stub from
the sink waste 'U' bend as shown in Figure 4, or to a new drainpipe of at least 40mm
diameter with a 'U' bend as shown in Figure 5. If connecting to a new drainpipe,
please note that the free end of the drain hose must be at a height of between
40–100cm and in a position where it is never immersed in standing water (Figure 4).
Water supply hose connection
The dishwasher must connected to a water supply where the water temperature does
not exceed 60°C otherwise the crockery may be damaged. The water supply pipe
must be terminated to enable you to connect the dishwasher water inlet hose to it. If the pipe work is new,
run water through the pipes to flush out any impurities and residues. Water inlet pressure must be above
0.4 bar (0.04MPa) but not exceeding 10 bar (1.0MPa).
Electrical connection
Connect the dishwasher to the electricity supply via a suitable 3-pin outlet socket. The socket must be
earthed and have an ON/OFF switch (Figure 4).
Note: The socket and switch must be accessible when the appliance is installed.
120mm
280mm
HOSE GUIDE
ADJUSTABLE FOOT
HOSE GUIDE
3-PIN SOCKET WITH SWITCH
WATER INLET HOSE CONNECTED
TO WATER PIPE VIA TAP
'U' BEND IN
40mm DIA.
(MIN)
DRAINPIPE
STUB IN 'U'
BEND
FIGURE 4
Connecting the drain hose to new drainpipe
FIGURE 5
FIGURE 2
FIGURE 6
FIGURE 3