Page 4
Gently lever the trim plates out of their
recesses in the appliance housing (Figure 4).
Unscrew the hinge pivot pin (Figure 5).
Unscrew the hinge from the housing (Figure
6), turn it round and using the same two
screws, refix it to the opposite corner of the
appliance. Screw the hinge pivot pin into the
hinge so that it points downwards, ready to
take the door. Refit the trim plates to their
recesses.
Gently lever the trim plate out of the hinge
housing in the corner of the door. Take the
opposite trim plate from the accessory bag
and snap it into place in the hinge housing
(Figure 7).
Locate the door on the upper hinge pivot and
support the door. Screw the centre hinge
plate into position using screws removed
earlier. The door should swing freely on its
hinges.
Fit the freezer compartment door to its pivot
on the centre hinge plate. Support the door
and take the hinge plate removed earlier from
the base of the appliance. Fasten this plate to
the opposite corner of the base using the two
screws.
Screw the adjustable foot into the threaded
hole in the opposite corner of the appliance
housing.
Return the appliance to the vertical position
and check that doors open and shut freely. If
necessary, level the unit using the adjustable
feet.
Important
Make sure that the voltage marked on the rating label on the product corresponds with the voltage in your
home.
This quality product has been tested and certified to meet all applicable UK electrical and safety standards.
Installation and controls
FIGURE 8
SPACER
CONDENSER
Door reversal (cont)
The appliance is designed to work in room
temperatures b16°C and +32°C. Do not
allow the room temperature to 32°C
otherwise the temperature inside the fridge/freezer
will rise.
Fit the spacers onto the condenser tubes (Figure
8) and put the cleaning tip in the drainage hole at
the back of the fridge compartment.
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
TRIM PLATES
PIVOT PIN
HINGE
TRIM PLATE
