1. Thermostat and lamp housing
2. 3 x wire shelves
3. Glass shelf
4. Salad/vegetable crispers
5. Ice cube tray and ice bank
6. Top freezer compartment
7. Large capacity drawer
8. Further freezer drawer
9. Bottle rack
10.Balcony shelves
11.Egg rack
Page 3
Parts identification
The parts are listed below to help identification.
Door reversal
FIGURE 1
1
2
3
4
5
7
8
9
10
11
6
Reversing the door may make installation
more convenient. The appliance must be
tilted and supported in order to carry this
out; it is therefore advisable to get an
assistant to help during this procedure.
Take care when fitting and tightening
screws.
Tilt and support the appliance, then unscrew
the hinge plate from the base of the
appliance housing (Figure 2). Also remove
the adjustable foot from the opposite corner
of the housing. Lift away the freezer
compartment door. Undo two screws and
remove the stop plate from the corner of the
door.
Turn the stop plate around and screw it to the
opposite corner of the door.
Support the fridge compartment door and
unscrew the centre hinge plate (Figure 3). Lift
away the door. Remove three blanking plugs
from the opposite side of the housing and fit
them to the holes that were uncovered when
the hinge was removed. Unscrew the stop
plate from the corner of the door, turn it
around and screw it to the opposite corner of
the door.
FIGURE 2
FIGURE 3
ADJUSTABLE
FOOT
FREEZER DOOR
STOP
PLATE
STOP
PLATE
HINGE PLATE
SCREWS
HINGE PLATE
PIVOT
PLUGS
