COOLSTUFF 18763, Руководство пользователя

Страница: 1 / 12

Manual
3D- pen
3D Pen 2 18763
What is PLA and ABS?
PLA is a type of polyester made from fermented
plant starch from corn, cassava, maize, sugarcane
or sugar beet pulp. The sugar in these renewable
materials are fermented and turned into lactic
acid, when is then made into polylactic acid, or
PLA.
ABS filament is one of the most common
materials used in 3D printing today. ABS, or
Acrylonitrile Butadiene Styrene, is a thermoplastic
that is easily molded when heated and hardens
evenly when cooled. ABS is made from monomers
Acrylonitrile, 1,3-Butadiene and Styrene with
petroleum as the basis.
Marking of product
Temperature tuning
EN
CoolStuff AB
Donaugatan 2
211 20 Malmö
www.coolstuff.com
+46 40 187200
info@coolstuff.se
Normally the filament output should be smooth
without bubbles.
196
Temp. - Temp. +
Increase the temp if:
Output filament surface color looks dim and dark.
Motor sounds strained.
Decrease temp if:
The nozzle has crackling sound.
The filament comes out with bubbles.
195
Trouble shooting
Symptom
Possible causes
Action
LED Power on
does not lit
Power adapter
or cord fault Replace power
adapter or cord
Circuit board fault
Replace the
circuit board
No filament
coming out
from nozzle
Nozzle blocked
Replace the
nozzle parts
Temp too low Increase temp
Wrong type of
filament Check filament
type: ABS or PLA
Filament
failed to load
Wrong size of
filament Check filament
size: 1,75mm
Filament end not
flat Cut the filament
end and reload
No heating Heating coil
damaged
Replace the
nozzle parts
Working angle
>65°
3D PEN 2
18763
Input:5V DC
Fila.dia 1,75mm
Made in China
Rev. 01 © Copyright 2022 CoolStuff AB