Coolix MPM3-10CRN1, Инструкция по эксплуатации

Страница: 17 / 26

42
A. FLooR DRAIN
1. Switch the appliance off and disconnect the power plug from the power socket. Move the appliance into a room or to
a location where water can drain directly on the floor without damaging any furnishings.
2 Loosen the discharge hose and let it hang. Then remove the bottom rubber stop from the hole on the rear side
3. Wait until all water has been discharged and replace the hose with the band, replace the rubber stop, and move the ap-
pliance back into the room.
B. PERmANENT WATER DRAINAGE
1. You can use the continuous discharge function of the appliance in the mode too. Please proceed as described in
the DEHUMIDIFY MODE for this.
IN DEHumIDIFY moDE
1 Please open the water filling cover on the rear side of the appliance. To do this, press the lower part of the flap gently
till the cover swivels forward.
2. There is a hose connection inside.
3 Insert one end of the hose included in the delivery scope into the connection. Guide the other end of the hose to a dis-
charge on the floor or to a water collection tank (capacity about 8 lt.).
4. Ensure that the hose is connected properly.
1
3