COOL HEAD RC 1390, Инструкция по эксплуатации

Страница: 6 / 67

GB
ORIGINAL INSTRUCTION
Installation: Location: Electrical
Freezer-RN, Refrigerator-RC: By placing the cabinet in an environment with high air humidity, it may be necessary to
acquire extra equipment for evaporation of the drip water in the pan near the compressor.
The cabinet can be installed freestanding against a wall.
Important
The cabinet must have sufficient ventilation and free air circulation beneath, above and behind the cabinet. The legs
under the cabinet will help ensure sufficient air space.
• Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly
removed from all surfaces. To prevent injury or damage to the unit, we recommend that the appliance should be
unpacked and set up by two people.
• The appliance should be placed on a solid level floor to reduce noise and vibration. Level the appliance by adjusting the
screw feet.
• Check that the power supply and voltage used comply with the details on the rating plate. The plug must be accessible
after installation
• Correctly connect and disconnect the plug. When inserting ensure the plug is fully engaged. When unplugging do so by
holding the body of the plug. Never pull the supply cord directly.
• If the appliance is to be shut down for long periods, switch it off and disconnect the plug from socket outlet. Clean the
appliance and leave the door open to prevent odour.
• Important! For your personal safety, this appliance must be properly grounded (earthed). This appliance is equipped
with a cord having a grounding wire with a grounding plug. The plug must be inserted into an outlet that is properly
grounded and installed. Consult a qualified electrician or service center if you do not completely understand the ground-
ing instructions. If doubt exits as to whether the appliance is properly grounded, have a qualified electrician check the
circuit to make sure the outlet is properly grounded.
• If the cable does not reach the nearest socket, either rearrange your store layout or ask a qualified electrician to fix a
new socket.
• If power is cut o ff, wait for at least 3 minutes before restarting the appliance to avoid damaging the compressor.
Note : If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before
operation.
Note : Before using the appliance for the first time, clean the shelves and interior with soapy water.
The cabinet should be placed in a room that is dry and sufficiently ventilated. To operate
efficiently it should not be positioned in direct sunlight or near warm appliances. Please note
that optimal cabinet performance is obtained at climate 4.
6