COOL BOSS CB-16H, Инструкция по установке и эксплуатации, Страница: 20 / 40

Cool Boss Evaporative Air Cooler
20
P/N 5900271 — June 2022 — Rev. A4
Fill the Water Reservoir
There are two options to fill the Reservoir, using a hose connected
to the 3/4 inch Water Inlet Connector with Float Valve, or manually
filling the Reservoir through the Reservoir Fill Inlet.
To fill the Reservoir:
You may connect to the Water Inlet Connector on the left side
of the unit using the standard 3/4 inch Hose fitting and a Hose
that is rated to 72 psi / 0.5 MPa maximum water pressure at
your location. Turn on the water and verify there are no leaks at
the connection point. A Hose is
not supplied with the Cool
Boss. See figure to the right.
If you are utilizing the 3/4 inch Water Inlet Connector, the
Reservoir Float Valve will shut off the water before the maximum
fill level is exceeded.
⚠
CAUTION Do not connect to a water source with a
supply pressure in excess of ≈72.5 psi / 0.5 MPa.
Alternatively, you may manually fill the Reservoir using the Water Reservoir Inlet found below the
Reservoir Fill Level Gauge. Remove the threaded plug and fill.
Add
clean water. Fill to the Max. fill level only, do not overfill. Monitor the Reservoir level using the
Fill Gauge located on the front of the Cool Boss. See the figure below. Water temperature must be
less than 113°F (45°C).
After filling, Replace the Threaded Plug, remove and dry any spilled water on the cool boss or floor
around the unit.
⚠
CAUTION Use only cold clean water to fill the
Cool Boss. No detergents or additives
of any kind.
Model Water Capacity
CB-16L / H ≈60 gal. / 230 liters
CB-28L / H ≈80 gal. / 300 liters
CB-36L / H ≈115 gal. / 440 liters