COOL BOSS CB-16, Инструкция по установке и эксплуатации, Страница: 24 / 40

Cool Boss Evaporative Air Cooler
24
P/N 5900271 — January 2023 — Rev. A5
To operate the Cool Boss for cooling
:
Before starting the Cool Boss, verify that the Media Holder Splash Guard over the Media is
secured in place. This will reduce the chances of water splashing out of the Cool Boss and
creating a slipping hazard in front of the Media.
Open a Door or Window, if using the Cool Boss indoors. Sufficient airflow for intake and exhaust is
critical.
Verify that the Cool Boss is connected to a Water Source through the ¾” Hose Inlet or the Water
Reservoir is full.
Close the Flow Control Valve (turn the Valve clockwise until it stops). See
figure to the right.
Verify at least two of the locking Casters are locked to prevent the Cool
Boss from moving with additional thrust from the Fan.
Plug-in the Cool Boss.
Press
Power on the Cool Boss Fan Controls. Refer to the Status Display
on the Control Panel to determine current settings and air temperature at
the Fan.
Press the
Fan button to supply power to the Fan. The Fan indicator will light
on the Status Display. Press Up

or Down

to adjust the power setting
to 25% or less.
Verify the Low Water Indicator displays Green
on the Status Display. If the
Low Water indictor displays Red , verify the water source is connected and providing water
under pressure. If filling manually, turn off the Cool Boss, unplug it from power and fill the
Reservoir.
If the Low Water Indicator is Green , Press the
Cooling button once to turn on the Pump. The
Cooling indicator will light on the Status Display.
Slowly
open the Flow Control Valve. Leave the Flow Control Valve on low until the top ≈30% of
the Media becomes saturated (30 seconds minimum). Once the top 30% of the Media is saturated
the Flow Valve may be slowly opened to increase the flow of water.
⚠
CAUTION Fully opening the Flow Control Valve onto dry Media will flood the Media faster than
it is capable of absorbing the water. Water will then be forced out of the Media onto
the floor and surrounding area. Carefully adjust the Flow Control to evenly saturate
the Media before increasing the flow of water onto the Media and before applying
more power to the Fan.
⚠
CAUTION Make sure there is water in the Water Reservoir before pressing Cool; if not, the
Pumps’ internal low-water switch will keep the Pump in the off condition.
⚠
WARNING Rotating Fan Blades! Keep hands, fingers, and loose clothing away from the Fan
when it is running.
Press Up

or Down

to adjust the Fan speed on the Control Panel or the Remote Control.
Increase the flow of water to increase cooling as the media becomes saturated.