Cookworks EP2178-V, Инструкция по уходу и эксплуатации, Страница: 4 / 8

Issue 1 6/4/2019 4
TO FROTH AND HEAT MILK
1.
Place the milk frother on a stable, flat, heat resistant surface and
away from surfaces that may be damaged by steam.
2. Fully unwind the cable and plug in. For safety do not allow the
cable to dangle over the edge of units.
3. Remove the milk frother from the stand and remove the lid.
4. Fit the whisk onto the spindle at the base of the milk compartment.
5. Add milk up to the lower level marked on the inside of the milk
compartment. Do not overfill (max 100ml) as milk may overflow
after frothing and ideally the milk should be at a starting
temperature between 5-10˚C.
6. Refit the lid, place the milk frother body onto the stand and the
switch indicator will illuminate red when connected to the mains.
7. Press the switch, the indicator will illuminate blue and the milk
frother will start to heat and whisk the milk.
8. When the milk has reached approximately 65˚C, the milk frother
will automatically switch off and the indicator will revert to red.
9. Remove the lid and pour out the milk.
10. To stop or interrupt the frothing and heating process, press the
switch to turn off the appliance or lift the body of the milk frother
from the stand.
11. If the frother is to be used again after a short interval the milk
compartment can be rinsed between uses (see step 2 cleaning
section). Wait 3 minute before restarting the frother.
Notes:
 Before first use clean milk frother in accordance with the advice in
the cleaning section.

This milk frother is fitted with a safety device that automatically
switches off the appliance after using for 5 consecutive cycles. The
indicator will flash blue for approximately 5 minutes and the
appliance cannot be used. When the indicator turns red the
appliance can be used again.