5
Popping Additional Batches of Popcorn - If you plan to pop more corn
immediately, transfer popcorn from the cover to another serving bowl. Let the base
cool, then follow steps 1 through 6 above.
Preparing Roasted Nuts
1. Add ingredients to the Kettle Crazy™. Add an even layer of nuts to the bottom,
then dry ingredients. Add liquid last. Do not roast more than 1 cup of nuts at a
time.
2. Ensure the selection knob is set to “OFF,” plug the cord into a 120 volt, AC
outlet only. Turn the selection knob to “NUTS,” and the stir rod will begin to
rotate and the base will heat. Note: The stir rod will continue to stir until the
selection knob is turned to “OFF.”
3. Do not cover or shake the Kettle Crazy™ during the roasting cycle. In 6 to 8
minutes, depending on the quantity of nuts being roasted, the roasting cycle will
be completed. Turn the selection knob to “OFF,” unplug the cord from the wall
outlet.
4. Using a non-metallic spoon, scoop the nuts out of the base and transfer to a
baking sheet covered in parchment or waxed paper and let cool completely
before eating.
Roasting Additional Batches of Nuts - If you plan to roast more nuts immediately,
let the base cool, then follow steps 1 through 4 above. You may need to clean the
base before roasting additional batches of nuts. Refer to “Cleaning your Kettle
Crazy™” section.
C
LEANING
Y
OUR
K
ETTLE
C
RAZY
™
Clean your Kettle Crazy™ After Every Use - Your Kettle Crazy™ should be
cleaned after each use. Always allow heating base to cool before cleaning.
Cleaning the Cover - Wash the cover and butter cap in warm, soapy water with a
dishcloth or sponge. Rinse thoroughly and dry. Do not use scouring pad or abrasive
powder on the cover as these could cause scratching.
Cleaning the Stir Rod - Remove the stir rod from the heating base by unscrewing
the securing knob counter-clockwise. Wash the rod and securing knob with warm,
soapy water using a dishcloth or sponge. Rinse thoroughly and dry. Replace the stir
rod after cleaning the base, making sure it fits over the square peg on the hub.
Secure with securing knob.
Cleaning the Base - Clean the non-stick surface of the base with a damp, soapy
dishcloth, sponge or nylon-scouring pad. Wipe the surface with a damp cloth and
dry. Do not use abrasive scouring pads or powders on non-stick finish as scratching
may occur. After roasting nuts, while the base is still warm, add warm water to soak
the sugar coating from the Kettle Crazy™, wait until it is cool and then dump out the
water. Wipe the surface with a warm, soapy dishcloth, then wipe with a damp cloth
and dry thoroughly.
After consistent use, the non-stick finish may discolor. To remove discoloration, use
a soft cloth saturated with lemon juice or vinegar and rub over finish. Then wipe the
finish with a damp cloth and dry.
DO NOT PLACE COVER, BUTTER CAP, STIR ROD, OR HEATING BASE IN AN
AUTOMATIC DISHWASHER.
This appliance has no user serviceable parts.
