CookMax 723006, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 35

page 14
UK
USER SECTION
3. OPERATION
Fig. A
Connect the appliance to the mains switch which has been
previously installed. Depending on the type of appliance, there are
two ways to turn on the motor. Press switch 0-1 (A) to position (1) for
the SPM appliance. For the SPL version, the switch 0-1 (A) must
also be in position (1), but the motor will start only when the juicer
lever is lowered on the fruit to be squeezed. The mechanically
activated indicator on switch 0-1 (1) will turn red when the motor is
on.
When the switch has been pressed, cut the fruit to be squeezed in
equal halves, take one of them and place it on the reamer, being
careful not to turn it. If using the SPL appliance with the juicer lever,
place the fruit on the reamer and lower the lever.
The juice will pass through the filter into the bowl where it runs into
a drainage tube and is collected in the juice collector cup placed
beneath the tube.
Useful advice
The juicer should only be used for the time period necessary to
actually squeeze the fruit.
Therefore, do not operate the appliance for long periods of time
when it is empty.
After using the appliance, it is advisable to disconnect it from the
mains by means of the main wall switch.
In the case of prolonged labor or heavy, the gear has got a thermic
which temporarily turn off the gear, to allow it to cool.
4. ORDINARY MAINTENANCE
Before proceeding with maintenance or cleaning, make sure that the
appliance is disconnected from the mains.
No particular maintenance is required. It is advisable to always clean
the appliance, the reamer, the filter and the bowl. To do so, use a
damp cloth.
The filter and the crown can be removed extracting up them and rinsed
under running water.
It is suggested not to wash the aplliance with water jets because
the item is not protected against pressured water sprays. Never
use bleach or chlorine detergents to clean the appliance.